Skip to main content

I got mine last night.  No videos or other pics because: a) its just like th others shown here, and b) the layout is torn apart for major revisions and I can run.

 

But this is a nifty picture.  Two Legacy Berks.  I like 'em both.  I will like 765 more when I change it to Santa Fe or Union Pacific but I won't get to that for a while.  That's 

 

 

DSCN0382

Attachments

Images (1)
  • DSCN0382
Originally Posted by joker34:

the mars light still works. its ok nothing real special. hopefully lionel dosent try to make me send the engine in for this. I knew I should not have messed with it oh well. we shall see what lionel says.

How did you remove the bottom screw? Tilted screwdriver? How do you pull the wires out of the lamp...so I can avoid that .

Last edited by cjack
If you look at the screws you need to take out to put the mars light on. Straight down you will still some kind of add on detail. It Looks like some kind of pump. There is a screw that holds that down. Remove the screw. Flip the engine upside down. The pump is you get it just right will then come out. This will allow you to get at the bottom screw.  Now on removing the headlight take the screw of of the back of the plate, slide the plate towards the engine and then very gently pull the headlight out. I found it easier to put the top screw in by removing the number board above the top screw.
Talked to Lionel today. They could not tell me the part number I needed as this is to new for them to have a parts list. So for 1.50 I ordered the headlight biodiversity off of the older legacy engine. Can't see how it would be a different part. Same 18 volt bulb has the same connector on the other end. We will see if this works. If not I will have to wait on the parts list to come out.
Originally Posted by joker34:
If you look at the screws you need to take out to put the mars light on. Straight down you will still some kind of add on detail. It Looks like some kind of pump. There is a screw that holds that down. Remove the screw. Flip the engine upside down. The pump is you get it just right will then come out. This will allow you to get at the bottom screw.  Now on removing the headlight take the screw of of the back of the plate, slide the plate towards the engine and then very gently pull the headlight out. I found it easier to put the top screw in by removing the number board above the top screw.

Thankyou, very helpful.

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×