How do you reset a legacy engine to factory settings using cab 3?
Original Post
Replies sorted oldest to newest
If it's a 2010 or later with the RCMC or the LCP2/LCP3 boards, switch the engine to PGM and assign it a TMCC address, that resets it.
If it's an early Legacy, assign the TMCC address and then AUX1-"1" for steam and AUX1-"2" for diesels.
That makes sense, I’ll try it.
@gunrunnerjohn posted:If it's a 2010 or later with the RCMC or the LCP2/LCP3 boards, switch the engine to PGM and assign it a TMCC address, that resets it.
If it's an early Legacy, assign the TMCC address and then AUX1-"1" for steam and AUX1-"2" for diesels.
If I recall correctly I actually think the LCP2/LCP3 you have to push and hold reset until you hear a ding I think.
either way a product number does wonders and the manual should that that information
