Skip to main content

Closed12 replies

Legacy questions

bill piercebill pierceOGR Forum Member

Ok crazy me I now own the Legacy Control System.Since Iam electronicaly challenged

I have some questions.

1. Iam keeping my exist TMCC system.As of now the command base is connected to one of the black terminals on my Z 4000 can Legacy be connected to same terminal? 

2. Will I have to redo all of my Engine ID`s ? I have three Legacy engines and fifteen TMCC

engines.

3. I throw one switch and all of my train related power,lights etc are off.can I shut Legacy off and on like that?If so how long is wait for Legacy to power up.

4. i have a plastic thing w/each Legacy Engine,I assume that all of the Engine info is on them so I just have to plug it in once.I also have an orange,tan,blue and black thingy that came w/Legacy do I need to plug these in also at some point?? 

5. Can I run all of my Engines w/ the cab 1 even if Legacy is installed.

 

I have version 1.3 and I am getting Suicidal

Original Post

Replies sorted oldest to newest

gunrunnerjohngunrunnerjohnOGR Forum Member SUPPORTING MEMBERDIGITAL SUBSCRIBER

1. You MUST disconnect the TMCC base from the transformer, leave that terminal unconnected on the TMCC base.  Just connect it to the Legacy base with the supplied cable.

 

2. You can keep the locomotive ID's, but you'll have to configure them in the Legacy.  You don't have to change the ID's.

 

3. The legacy base powers up in about 3-4 seconds and is ready for a connection.

 

4. You just use that to load the Legacy locomotive characteristics.  Truthfully, you can do it all from the remote, it's just easier to use the module.

 

5. You can run them all from the CAB1, obviously you will NOT have access to the unique Legacy features like the quilling whistle, etc. for the Legacy engines.

cbojanowercbojanowerOGR Forum Member SUPPORTING MEMBERDIGITAL SUBSCRIBERMEMORIAL SUPPORTER
Originally Posted by bill pierce:

TMCC works fine now so I guess I can wire Legacy to same terminal

Thanks for your help

Disconnect the TMCC base from the wire, move that wire to the Legacy base. Use the large cable that came with your Legacy set to connect the TMCC base to the Legacy base NEVER allow your TMCC base to connect directly to your track again

 

or

 

After realizing you are not using your Cab-1 and TMCC base anymore (because Legacy is that cool) sell it to the DCS guys at an inflated  price and enjoy Legacy

Views: 1,152
Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×

Access to this requires an OGR Forum Supporting Membership

OGR Forum Supporting Membership

Help support this forum with an OGR Forum Supporting Membership.
You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM!
A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!


    OR     


Access the ALL the OGR VIDEO FORUMS AND  over 300 back issues of OGR
with a DIGITAL SUBSCRIPTION!



$12.00 per 12 Months (plus tax if applicable)
×