how do I connect my new legacy cmd system to (2) ZW -275 to 4 loops, previously used TMCC
Original Post
Replies sorted oldest to newest
I have two Z4000's with two TIU's with wires going to two terminal blocks. One for power, which is divided into four separate blocks, one for each mainline. The ground terminal block is all one and I just attached the ground wire from the Legacy Base to that...................Paul
If ALL your loops are "common" ONE wire from your Legacy Base to the Track Common. NOT to your TMCC Base !
daddylonglegs posted:how do I connect my new legacy cmd system to (2) ZW -275 to 4 loops, previously used TMCC
do you still want to have or want the TMCC hooked up?
do you have DCS?
are all your loops connected?
no tmcc in future and no dcs, some of my locomotives are conventional, but most are legacy and tmcc
loops not connected currently, but will do in near future via switches
one wire to your biggest loop and most likely you will have signal to all loops.
this is based on others reporting their test track not being connect to a layout and signal being picked up on test track.
