I have a TMCC version of the Burlington UC30C diesel. The flywheel magnet has broken into 3 pieces. I've received a new motor but cannot figure out how to replace it. Is there a trick to it or some kind of hidden latch? I've temporarily epoxied the magnet back on as shown in the picture but I do not think it will last for very long.
Thanks,
Chet Klyn
Replies sorted oldest to newest
The screw that you probably cannot find is reached from on top where the wire harness goes down to the truck. Look straight down and you will see it. Take that out and the truck will drop down.
I'll give it a try Friday, I'm working the next 3 days 6AM-6PM. Thanks for the info.
Chet Klyn
Changing the motors on those U30C and SD40T from that time frame are a dirty bugger to get to. As chuck says you have to go thru holes in the truck from the top down to get the 2 screws out. Turn truck side to side until you find them.
I cringe every time I've got to dig into one of those.
Jim
Changing the motors on those U30C and SD40T from that time frame are a dirty bugger to get to. As chuck says you have to go thru holes in the truck from the top down to get the 2 screws out. Turn truck side to side until you find them.
I cringe every time I've got to dig into one of those.
Jim
Access to this requires an OGR Forum Supporting Membership
