I just purchased a new motor and six-wheel truck for my Williams FM. I tried to use the old screws to mount the side frames and motor, but none of them fit, all were too loose. To make matters worse, both types of screws are sold out on WBB parts web site.
Any ideas what type of screws I can use?
Replies sorted oldest to newest
So Williams changed all the screw hole sizes in the frame? I assume the motor mounting screws go into the frame like the truck side screws?
Y
So Williams changed all the screw hole sizes in the frame? I assume the motor mounting screws go into the frame like the truck side screws? Have you tried an ACE Hardware?
Y
Yes - take the female piece with you and try the hardware store. If too long they can be cut off with a Moto-Tool, etc. Brass or steel will do.
Before you cut off the screw, thread a nut on to it. After you cut, chamfer the end with a file and back the nut off. It will help you clean out the threads were you cut.
Thanks for the advice, guys.
Home Depot actually had a board with screw ends on display, and I was able to find which one fit the motor mount and side frames. It was a #6-32, and as D500 says, I was able to cut them down with the dremel.
Now my FM is pulling better than ever. Took off like a rocket with four 70' cars. I still have the other end to do, and yes, next time I'll do what Dan says, as it was a little tricky to secure them by the round head for cutting. The nut will make it easier to clamp.
I also had to clean out the screw openings in the side frames with the drill to make the new screws fit.
Well, learning (and sharing knowledge) is part of the hobby.
Thanks again, guys.
Access to this requires an OGR Forum Supporting Membership
