MTH 20-2904, WONT COME ON

If you have red output of TIU to center rail you should be good.  

Have you tried to get the new PS-3 to add individually?  Make sure in 3R position, polarity switch doesn't matter normally when in 3R.  G

You added the engine to the remote prior to attempting to use it in a lashup, correct?

Well gang thanks for the ideas, I do believe I have some other, issue , like the track

Pulled all off but 1 lighted car, and it does, not come on,  so  I also need a

9 volt , for the micrometer.  I just wasnt planning on something of this nature.

Be back, after get battery.

ok, I'm back.  1 piece of track replaced,and fuse replaced.

This is a forum engine, that has been ran; cause it will smoke in conventional.   However,  1 small light on the back, (upper left hand corner), and

same style light in the front comes on, and immediately, goes off.  Do I need to

run, in conventional to charge anything up.  I placed it on my 2nd Tiu, track, and remote

comes up again NO DCS, engine to add.

perplexed!!!  I really need on my TIU tracks and not the conventional tracks due to passenger car sizes.          THANKS

The red and green markers will flash at startup on some engines.  Does this engine run in conventional?  Have you tried a recover engine?  On your test track with no other engines on, did you try a read?

Are the wheels and pickups clean?

After that it needs to be tested by a tech, the Power Supply board can have some damage and it is killing the DCS Signal.  That is repairable.  G