Thank you for the help for the engine problems. I did check the battery with a meter,and it read 8.4 volts, however under load it dropped, so it seems I had multiple problems. I have since charged the battery and done a 27 reset and an 18 reset. I have sent the boards to my brother who has the chip reset kit. Since I have removed the boards I have some questions on some connections to the board. There is a switch in the tender that is not labeled, I would like to know what it's function is and where it is supposed to connect to the board. Also the green wire that goes to the engine from the tender which feeds the smoke unit what is it connected to in the tender.There are two other connections on the board labeled LP1 and LP2 what are they supposed to connect to.The last one is on the other end of the board underneath it says coil and below it says coil again. I did draw diagrams when I took this apart, but I did miss verifing a couple connections. Any help with this would be appreciated. Thank you .Robert
Original Post
