I have a MTH Texas And Pacific
Steam Engine that I purchased in the 90's ( I'm sorry I don't have the catalog number yet ) It only has a whistle and it has stopped putting out smoke. The fan is running fine and the wick seem to be ok but it will not put smoke out.
My question would be is this caused by the heating elements? Can they be replaced or would I have to get a new board? Sorry If I'm saying the terms wrong but new in trying to figure out the repairs.
Thank you for your help,
David
Replies sorted oldest to newest
The 1995 ProtoSmoke unit has on-board electronics to regulate the smoke. So, it would be something with the electronics or the resistors. The components on the board are common components, so it could be fixed, but I'm guessing you aren't able to diagnose the issue.
Thank you GUNRUNNERJOHN for your response. I will have to get someone to look at it.
Thanks again,
David
If all else fails, they're still available from MTH I believe. AA-0000011 Smoke Unit.
I will check it out. Thank you for your help.
David
Yes, element can break and open. Yes a component can fail on PCB or a trace open. It is repairable as long as the board did not burn up. Or replace it. Normally repairing is cheaper. G
Thank you very much for your response back GGG. After Christmas I will have to get it looked at or order a new board.
Have a great day,
David
Access to this requires an OGR Forum Supporting Membership
