Yep, you have to take it all apart to put the new bracket on.

Be very careful.  The three wires that are soldered to the assembly make removal difficult to and replace after you unsolder them.  The entire assembly is very fragile.  A stupid design for replacement, 

Bruce

I've replaced a couple of the brackets, it's a little tedious but can be done if you're careful.  Obviously, a fine tipped soldering iron is a big help here.

So the 3 wires need to come off as well as unsolder in the other tabs on the PC board so that it comes off of the pins ?

Well that didn't go well, the center pin on the little switch broke off ,  so now I need that 3 pin switch that solders onto the PC board

weeeeeeee. Banner day

See, you had to be VERY careful.

Now you probably need a new thumbwheel.

Yaaaaa, if the thumb wheel comes with that little switch on it than yes, I talked to Midge earlier and all they have is the cradle, no thumb wheels or that switch in stock, possibly once the other folks take over but who knows at this point

I was going to send you an email but you don't have an email address in your profile.

Hi John, I just looked at my settings and my email is in there but anyways it's

curleydavid2@twc.com, feel free to shoot me an email

thanks

Must be invisible ink, all I see in your user profile is this.  The rest of the page is blank.

Naaaaa, just the way my day has been going, but you just changed the flow, I sent you an email

Tyank You