The engine runs and smokes up a storm. The. Bell and whistle are uncontrollable. They sound off at will I thought maybe the battery was bad. 20 years ago I replaced the batteries with BCRs and used a tape gun to record same on the tenders. This tender doesn’t have the marking. So I opened it up and there was the BCR. I used the z4000 to do a reset. It seemed to take I saw all the blinks etc.
Replies sorted oldest to newest
That is a conventional PS-1 board. So it should run like a conventional engine. If you have a pinched wire on motor you can get an offset to trigger bell. Not sure what you mean by blinking lights for reset. Not how it works. Look at your PS-1 instructions. Also you regulators are not mounted right and that can cause issues too. G
@GGG posted:That is a conventional PS-1 board. So it should run like a conventional engine. If you have a pinched wire on motor you can get an offset to trigger bell. Not sure what you mean by blinking lights for reset. Not how it works. Look at your PS-1 instructions. Also you regulators are not mounted right and that can cause issues too. G
Sorry blinks on the Z-4000. What about the whistle that blows when ever and once it starts it doesn’t stop?
Your shorting AC power because the regulator is missing insulation to the bracket (most likely). G
Access to this requires an OGR Forum Supporting Membership
