Skip to main content

I recently purchased a 464 Lumber Mill with the 464-45 Vibromotor. The motor vibrated but the pulley did not move. The plate to which the string is attached came loose as seen in the picture. I plan to use a small nut & bolt to re-attach.

IMG_0878Does the tab (where the string attaches) point at the 1 o'clock position or the 4 o'clock position?  The hole the rivet fits into is hex-shaped. Does anyone have a picture of this motor that would show which position this should be attached?

Thanks for the help

Attachments

Images (1)
  • IMG_0878
Original Post

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×