Skip to main content

I have an original G TIU That has software version 5. I have only been using Fixed 1 & 2 all these years with a z4000 and the z4000 receiver from the remote commander. Using the DCS remote. Have even been using the Wi-Fi adapter and App. DCS has been working great on the 2 fixed channels. And still does. Decided to build a programming track area using variable 1 & 2 and two z1000’s. setup them Up as fixed....1st using the DCS remote...made sure DCS was turned on for all channels. There is full voltage to the programming track But still no DCS on the  variable channels......any engine placed there shows not on track or out of range. tested the wiring run to the programming  track by using one of the fixed outputs. And all was good. So it’s gotta be the TIU....am I missing something? Even looking through the Wi-Fi app I do not see anything wrong..except in the premium App there is only a track selection for variable 1 & 2. Nothing for fixed...unless you go to select the TIU and its setup....

Attachments

Images (2)
  • image
  • image
Original Post

Replies sorted oldest to newest

 

(Disregard this post, re-read your post, and you indicated that you were sure you had the DCS Signal ON for ALL Channels)...

Is it possible that you have the DCS Signal turned OFF for VAR1 & VAR2 via the DCS Setup function.

To get there via the Remote:

Menu / Control / DCS Setup / (Select) VAR1 /

Softkey 1 ~ Turns ON the DCS Signal

Softkey 2 ~ Turns OFF the DCS Signal

Repeat the same for VAR2...

(I'm not sure how to do this via WIFI and the App, or if it's even possible. But you can get there via the Remote with the procedure I posted above.)

Here's hoping that this gets you to the promised land.

If this doesn't work, maybe someone has some additional insight...

 

Last edited by Pat C...

Add Reply

Post
The DCS Forum is sponsored by
×
×
×
×
Link copied to your clipboard.
×
×