Skip to main content

Replies sorted oldest to newest

Thanks for the replies! I have the dz1002 controllers but since I'm already using the o22 controllers on my other switches (Super O 112R's) I'd like to use one if I can. Al, I tried an o22 but the switch machine didn't activate and the red led lit, no matter which direction I moved the controller lever. I was concerned about damage to circuit boards so didn't press the issue. I might have missed something or wired it incorrectly. I'll give it another try.

rickoshay posted:

Thanks for the replies! I have the dz1002 controllers but since I'm already using the o22 controllers on my other switches (Super O 112R's) I'd like to use one if I can. Al, I tried an o22 but the switch machine didn't activate and the red led lit, no matter which direction I moved the controller lever. I was concerned about damage to circuit boards so didn't press the issue. I might have missed something or wired it incorrectly. I'll give it another try.

Sounds like you have the switch wired wrong. The center wire at the switch is for common wire to the switch control(center screw at switch housing) and the outside wires are the control or switches wires.

Super O switches are differently wired if I am correct. Unfortunately I didn't use any Super O track.

Lee Fritz

I tried the o22 controller again this morning and no joy. It was wired exactly like the dz controller but still will not switch the machine off of the mainline direction. The dz controller works perfectly wired this way. I'm just going to use the dz controller, especially since one controller will operate both switches according to Dennis from Z-Stuff. Thanks again for the input!

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×