After I loaded the new 6.1 software, the on/off sw on the remote no longer worked after holding it down to load the program, help.
thank you MONK
Original Post
Replies sorted oldest to newest
Hi Monk,,, Don't panic , this has happened a few times here on the forum in the last few years. It's fixable, however how... that's the 64 thousand dollar question.
Maybe a reload of the software starting with new batteries, and making sure the remote is in the "off: position by removing one battery and reinstalling it. The Loader will tell when to hold down the on/off button.
I 've had it happen and eventually it took after number of tries , I even went back to the older software version (that worked as well 
The only reason I posted was to let you know it's fixable. You don't need a new remote.
Monk,
A few thoughts...
First, ensure that the on/off button isn't imply stuck in the on position. The button should have some play, the same as any other button. Then, check al of the buttons. If any one is stuck-in, the power button won't work.
Next, try loading the software again.
Last, take the batteries out and let the remote sit for a couple of days. Then, put the batteries back in and try to turn it on.
I've never had a remote with this problem that one of the above solutions hasn't resolved.
MONK, if all fails, open the remote and clean the contacts behind the rubber button pad and on the pad itself with a Q-tip and denatured alcohol. I do this to all my remotes whenever I notice the buttons don't respond properly.
