3 of the 4 rubber feet came out of the panta
graph. I found them, but can’t get them back through the holes. Any suggestions?
Thanks
Attachments
Images (1)
Original Post
Replies sorted oldest to newest
Those are supposed to duplicate the insulators on the prototype. It is, usually, easier to put them into the pantograph than press them into the body. A little liquid dish soap or hand soap might make it easier and you may have sort of “screw” them in.
Thanks, Dan I will try that.
on some insulators one end tip is smaller then the other...try the smaller one in the pantagraph...I have 14 g's and i know it can be a pain....good luck...joe
Holding it with needle nose pliars and after dipping the tip into dishwashing solution , I was able to maneuver the smaller end through the hole on the pantagraph. Thanks to all.
