I have been able to build lash ups as well as a previous lash up using the same two engines I tried today. My new WTIU has been working fine up until today. Today when I hit the done button (top right), I get: Command Failed, Lash up initialization failed.
What would cause the command to fail? How do I correct this? HELP!
Thanks, Dave
I had this same exact issue with my first WTIU, Everything appeared to be working properly, but I could not create a lashup, getting the same error as you at the end. My diesels were running without any issues, so I started a signal strength test. Found that the signal was going up and down at a crazy rate. In the app I setup variable 1 to be a fixed input and switched all of my connections to variable 1, instead of fixed 1. The signal tests were normal, with little or no fluctuation, and I was able to successfully create a lashup. This appeared to indicate a faulty fixed 1 channel, exchanged the WTIU for another one and didn’t have any issues after.
Access to this requires an OGR Forum Supporting Membership
