programing the LCS iPad for a Mill House 34" turntable

Have you contacted Al from Millhouse as I'm sure he can assist you.

jim r

Programming the LCS is easy but it needs the Zstuff serial driver with an amp circuit

I have all the electronics & cables. 

Once you get the hang of it, it's pretty easy. I don't know if you can do it off line easily. You would have to know the positions of where your whisker tracks are located. We did a demo with Al at York and once we got past the WiFi issues it went pretty quickly. Just make sure you advance the track number. It always goes back to 1. 

I spoke w/ him prior to this post & about setting up the iPad to the turntable & he said Marty E from the LUG did the setup at York & he did not know any of the procedures. He suggested posting to this forum for assistance. 

I'll see if I can write up a quick procedure. I probably won't be able to get to it until after the weekend. It's not too bad. Like I said if you know the 4 digit position of the whisker tracks it goes a lot quicker. If no it's a little trial and error. You have to ball park the track and then make small adjustments to get them to line up. 

Thank you.

Marty, thanks for the reply. I couldn't remember if wifi was hooked up prior to programming tracks , but thought it was connected prior.

Al

We did the programming hooked up.  I'm not 100% sure programming off line is an option but I believe you can get all the positions set.  Like I said if he set up the keypad with the 4 digit positions, then it should go fairly fast.