Skip to main content

Have the Original BB purchased in 1988. Little use. I am an experienced Train Guy (over 50 yrs) so first thing I always do is check everything out for proper operation 

Because of age- knew it needed a new battery before starting anything up. S0- New BCR installed 4/30/2020. Engine powers up goes forward and backward- with bell and steam whistle sounding fine.

Using QSI Power programmer  to reset everything rather than transformer handle motions.

First Problem- no chuff sound in motion. Selected #6 which is reset for chuffing volume. Ran fine after programming. Next day startup gave no chuff sound at all. Also tried selection #18 which is factory reset for default settings. No chuff sound at all.  I have triple checked all the voltage settings and wires are properly hooked up.

Second Problem - is smoke unit was properly filled(15 drops) before starting anything up., following the factory instruction manual and blew down the stack to start it going. Lots of downward smoke that way(so I know the smoke unit is good) - but- no smoke is coming out the stack upward. So I suspect that the smoke fan no good?

Any help would be appreciated. My email is in my profile.

Thanks. Glenn Spencer

Original Post

Add Reply

Post
This forum is sponsored by MTH Electric Trains
×
×
×
×
Link copied to your clipboard.
×
×