Skip to main content

Closed4 replies

Proro-Coupler Wiring Harness Aux Tender

bruce benziebruce benzieOGR Forum Member

I guess this post is for Gunrunner or an other tech.  Auxiliary Tender Wiring Harness for the MTH 611 J.

This harness is going to be installed in the J main tender which has a PS2 upgrade in it. 

Following the diagram MTH included with the kit , coupler wires, it LOOKS? like the brown wire on

the 12 pin protosound circuit board connector goes to the black wire  on the aux tender kit 4-pin

connector, and also goes to the upper black wire on the protocoupler installed in the tender (looking

at the coupler from its underside) - correct?

The brown wire on the selector switch should go to the lower black wire on the coupler when looking

at the couplers underside.

The black wire on the selector switch LOOKS like it goes to the purple wire on the 12 pin protosound

PS2 upgrade circuit board connector.

 

The instruction sheet warns to follow directions to the tee or risk a dead short.  I do not want to do that!

 

The back up light is no problem, dark green connector (polarized) to the light green connector on the light green

connector on the 12-pin protosound board harness.

 

Need input to prevent a disaster.

 

thanks,

bruce

Original Post

Replies sorted oldest to newest

G GGGOGR Forum Member

It would be hard to tell you what the directions are saying without the directions posted.

 

The brown wire from the 12 pin is the ground to fire the rear coupler.  The purple wire is the positive DC voltage to power the coupler.

 

So the tender coupler needs a purple and brown connection to fire.  One comes via the switch to select which coupler fires, and the other comes directly from the 12 pin to each coupler.   What color wire is on the center post of the switch?  G

bruce benziebruce benzieOGR Forum Member

 

John,

 

The way I read the diagram from MTH - the brown wire (coupler connector) goes to the black on the 4 pin female connector.

 

The purple should go to the black on the center position of the selector switch.

 

That is exactly the information I was trying to verify. 

 

I think you and I are on the same page.

 

Let me know how it works.

 

bruce

Views: 559
Post
The DCS Forum is sponsored by

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×

Access to this requires an OGR Forum Supporting Membership

OGR Forum Supporting Membership

Help support this forum with an OGR Forum Supporting Membership.
You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM!
A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!


    OR     


Access the ALL the OGR VIDEO FORUMS AND  over 300 back issues of OGR
with a DIGITAL SUBSCRIPTION!



$12.00 per 12 Months (plus tax if applicable)
×