Hi All,
I have a PS3 4-6-0 Steamer that came in a ready to run set. Most of the the time it runs fine. Other times the engine gets stuck in one direction, usually reverse. I usually run the engine conventionally with a z1000 brick and controller. At first I thought it may be the buttons on the controller not dropping the voltage enough but the other day I ran it in DCS with the remote commander and it did the same thing. If I turn the power off and on at the power strip it will start up and run fine again. Any ideas as to what can be causing this? I bought the engine last November so it is still under warranty.