Hello All. I'm trying my first PS3 upgrade (diesel) kit. I'll be putting it into a USA G scale diesel.
I found some things confusing as I lay it out. There's several wires that I identified that could go to the smoke unit. There are 2 brown wires from pins 8 and 10 that on the diagram are shown going to a generic box representing the smoke unit (heater). I think they are duplicates? (goes to same place or just use 1?)
There are 2 green wires from pins 16 and 18 that show smoke fan. I think those are duplicates also?
There's a purple wire on pin 14 that says it's PV and goes to the smoke unit. I'm guessing that's + to the smoke heaters??
On the other side of the diagram there's a grey wire shown going to another picture of a smoke unit and it's labeled p5v. I'm guessing that's the grey for the + smoke fan? to go with a green?
So the problem is there should be 4 wires and there are 6? they only describe four in the directions. They do state the different colors but I don't know if it follows the PS3 connector?
