Hi everyone, I hope someone can explain to me why when I let my PS2 switcher go threw the full PA at startup when its done it takes off at full speed without even touching the thumb wheel on the remote!
Any help would be great!
Here is a photo of the switcher.
Replies sorted oldest to newest
it's supposed to return to whatever speed it was set to when you enabled the PFA. So does it do that or just full speed? Are you running this in command?
Maybe something in the DCS software or sound set PFA is wrong? It's happened before. A version of DCS had the engines in a consist act up. The lead engine did something different than the rest of the consist at the end of the PFA.
Are you using DCS version 6.1 (or the latest) in everything?
Hi Joe, Yes I am running this in command, I am not sure but I think its 6.1. But to be honest I don't know how to check. I haven't got that far into Barry's book. It seams all my other engines run fin after the PA, but I will try them all later today!
Mike, is it OK if you do startup without PFA?
Lew, I know. Just trying to figure it out!
Joe, when I start up the DCS remote it says Version 6.00
Engineer-Joe posted:it's supposed to return to whatever speed it was set to when you enabled the PFA. So does it do that or just full speed?
try setting the speed to 10 MPH before using the PFA. See what it does after.
Mike
You gonna hurt my feelings if you don't get that playing well with you.
Larry
Larry, I think I have it worked out, I still have a little more testing when time permits! Maybe tomorrow! I did an engine reset on my other switcher and it worked great!
Access to this requires an OGR Forum Supporting Membership
