Tried first project - Outhouse - have questions about sizing

The short answer is... Yes.   Using the CURA slicer... if you have 'uniformed scaling' checked you should be good to go i.e., the other dimensions will adjust automatically.      All slicers have this function... although they may call it something different.  I just downloaded the same file and went with 82" from floor to roof ridge... it gave me about 6' 2" door height.

Thanks,, about how tall was the final printed item?

Chris,  Without going upstairs and measuring it... about, 1.70" inches from floor to the peak of the roof.

Sounds like a crappy project.

Dennis, that sounds about right. I was just seeing how close my conversion was

@BenLMaggi posted:

Sounds like a crappy project.

Yep it's the official OGR Crapper

(If you been around here for a long time, that should bring back memories)