Skip to main content

4 replies

Variable 1 Dead

lehighlinelehighlineOGR Forum Member DIGITAL SUBSCRIBER

I have a Rev H1 TIU. I can get no voltage to pass thru Variable 1. The TIU is powered via a wall wort to the Aux port, and blinks 4x when powered on. This is expected as I had previously set this TIU to TIU4. I can get voltage thru Fixed 1, Fixed 2 and Variable 2. Just to confirm that I did not have something haywire with the communications to the hand held, I deleted both V1 and V2 and then re added them.  (TIU Tracks) Variable 2 again responds and Variable 1 does not. I pulled the cover off and checked continuity on all 4 fuses. All are OK. With the fuses in place, and the meter leads placed on the input black and output black for each channel, all allow current to pass, so they are good. I gave the board components a once over with an unprofessional eye, but could not discern any burn marks. Suggestions for what to check or do next?

 

Chris

LVHR

Original Post

Replies sorted oldest to newest

Mike CTMike CTOGR Forum Member

There is programming that turns the output of Variable one and Variable two (on/off).

Menu/System/DCS Setup/TIU1/Variable1/ (soft key)On

Menu/System/DCS Setup/TIU1/Variable2/(soft key)On

You could also try:

Menu/System/DCS Setup/TIU1/Variable1/(soft key)Fixed

Menu/System/DCS Setup/TIU1/Variable2/(soft key)Fixed

 

Needs to be checked before assuming something is broke.

 

Last edited by Mike CT
lehighlinelehighlineOGR Forum Member DIGITAL SUBSCRIBER

Guys,

 

Thanks for all the suggestions. It turns out the first one (GRJ's)was correct, at least as far as I went with the testing tonight. I was able to run a conventional engine on all 4 circuits, and use the handheld to vary the speed when connected to V1 or V2. Tomorrow night I plan to dig out a PS2 engine and see how that behaves. I will start with charging the battery...

 

Mike, I'll keep those sequences in mind. I hope the reset would have left all the signal generators in the ON position.

 

Chris

LVHR

 

 

Last edited by OGR CEO-PUBLISHER

Add Reply

Views: 225
Post
The DCS Forum is sponsored by

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×

Access to this requires an OGR Forum Supporting Membership

OGR Forum Supporting Membership

Help support this forum with an OGR Forum Supporting Membership.
You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM!
A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!


    OR     


Access the ALL the OGR VIDEO FORUMS AND  over 300 back issues of OGR
with a DIGITAL SUBSCRIPTION!



$12.00 per 12 Months (plus tax if applicable)
×