VL GG 1 help

Same answer I gave you in the other thread you asked...

No trick. The correct sequence is PGM /RUN switch to PGM then ENG 48 then SET then AUX1 then 9, PGM/RUN switch to RUN.

Sorry, Marty. I somehow lost the handle to my original post.

I reset the engine as follows: ENG 48 SET (horn sounds) AUX1 9 SET (horn sounds).  I set the switch back to RUN.  When I restart the engine I still have no smoke.  On page 14 of the manual it say after setting the smoke unit will run for about 45 seconds.  I went back through setting again with the sound turned down so I could hear the smoke unit - no noise.  I tried cycling it back and forth with the 8 and 9 keys but still no joy.  The smoke unit works fine when I press 9 and turns off when I press 8.

Am I missing a step somewhere?

Thanks for your help.

The correct sequence is PGM /RUN switch to PGM then ENG 48 then SET then AUX1 then 9, PGM/RUN switch to RUN. 

Do exactly as MARTY stated above.  In your statement you hit set after the AUX1 then 9,  don't do that.

You still need to turn the smoke unit on using the + but once on it should cycle every 5 minutes. It starts "on". 

Thanks Marty and Laz.  Following that sequence the smoke unit is working.  With the sound off I can hear it running but I now have a different problem - there is no smoke.  In the not prototypical mode there is smoke so I'm guessing there is a problem with the heat sensor in the smoke unit.

I will call Lionel on Monday.

Once again, thanks for your help.

Dan, please post what you learn from Lionel.  Thanks.