I know this has been asked before, but I have not found any answers?? Does the Flyer Cow on the track work with fastrack? I am guessing it does, but how would be the best way to wire it?? Thanks! for your time in advance in helping me out with this question.
Dana
Replies sorted oldest to newest
Thanks for the reply. I did see the diagram posted on the group that shows the cow on the track being wired using the nylon pins which is not available on fastrack as you can't easily remove and replace pins. If you were to use an infra-red MTH or other tracking device how would you wire it with the cow on the track accessory? Dana
Fastrack has insulated track sections as part of the product line. You can also just take the links across the outside rails out, then use a Dremel cutoff wheel to slice the track on a section at each end of the run and you have instant insulated rail.
We're talking O-scale and not S-scale, right?
You may be right Mark, I guess we'll have to wait for confirmation. 
I'd consider the Lionel 153-IR track side sensor for S-scale, it works very well.
Access to this requires an OGR Forum Supporting Membership
