Does anyone know where do get the jumper plugs that lionel recommends to use to distribute the power from 2 blocks ? Are they a lionel product?
Replies sorted oldest to newest
The plugs say unavailable from Lionel.
But these are the plugs from Mouser, Mouser part number 538-03-09-1032
http://www.mouser.com/ProductD...uBYkw8Qy79YRoA%3d%3d
And these are the female pins in it, Mouser part number 538-02-09-1104
You need two pins, one pin at the narrow edge and one at the middle which are connected together...shorted together
Here's the Digi-Key link...
http://www.digikey.com/product...;keywords=0003091032
Digi-Key shows the housing correctly, without the panel mount tabs. But the part numbers are correct for Mouser or Digi-Key.
I corrected my first post about five times trying to figure out the tabs or no tabs and finally figured out that the Mouser picture is wrong.
Just to be sure, these are the plugs you plug into the two empty inputs ZW-C when you only have two PowerHouses. And they distribute the two PowerHouses to the four outputs. Right?
You are correct, plug the Power House into A and C the plugs then share the power output with B and D..
Marty
I have in stock, drop an email if interested.
Chuck