All connections are as specified in manual and motor turns freely . What am I missing? Thanks
Original Post
Replies sorted oldest to newest
How clean is the drum and fingers? I've had that happen where there is dirt on the contacts and it will not work at all.
Thanks, Cody
Ill double check. I sprayed some contact cleaner in that area but it didn't help. Holding off taking it apart >
The unit has been sitting a while also
In addition I have a 2025 same thing
What about brush plate holders ....?
Thanks, Cody
Ill double check. I sprayed some contact cleaner in that area but it didn't help. Holding off taking it apart >
The unit has been sitting a while also
In addition I have a 2025 same thing
What about brush plate holders ....?
1. Are you able to apply voltage directly to the motor to confirm that it is working properly and eliminate it as an issue ?
2. Can you look inside and see if any of the e-unit contact fingers are broken or twisted and to make sure the drum is squared in the frame ?
3. Are all your ground contacts good ?
I agree with Richie on making sure the motor runs directly. Check the brushes and make sure they are good and clean too.
