Skip to main content

Barry, if you haven't sent the list of questions off to MTH R&D, here's a couple to add to the list regarding the troubles of resetting the DCS ID address.

 

1. Could future releases of the DCS Remote Commander include a factory reset command that sets any PS2/3 engine on the track back to the factory default address?  If possible, perhaps such a command could be triggered by simultaneously pressing two or more buttons, such as DIR and PFA.

 

2.  Could future PS3 engines (or existing PS3 engines through a software upgrade) add a new bell/whistle combination, such as 1 whistle + 6 bells, that would reset the DCS address to factory default in conventional mode?

 

Thanks,

Brother Barry!

 

Marty Elbeck pointed out to me that I had signed up for the DCS Dinner on the wrong thread yesterday, it was for the last one, the 14th DCS meeting!  Search engines are a great tool, but I bit on the first thread that showed up when I searched under "DCS dinner"!

 

Thanks Marty, for heading me in the right direction.  I'm looking forward to seeing you too!

 

So, please put me down for 2 seats at this one.  Looking forward to seeing you.  Missed October's York and it seems like I haven't seen you and my other train maniac buddies for years.

 

YorkBoundBear (and entourage)

Last edited by Bearlead
Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×