Skip to main content

Hello all.  I finally got around to connecting my Base 3 to the layout.  I have been running it in Conventional for the last several years after my old cab1 remote failed.   Now I'm trying to connect my Base 3 to the ZW-C but am having no luck.  The ZW is starting in command mode when the Base 3 is on so it is seeing the signal but that's it.  When I press the program button it does not attempt to problem, no lights flashing.  The green light stays steady and i have no output.  Could this be a failure within the ZW or does it see the Base 3 but not recognize it?  I'm not sure where to go from here, I cannot find anyone who has connected the two or a guide to do so anywhere.   Any guidance would be appreciated.

Thanks in advance,

Nick

Original Post
@nschaaf posted:

Hello all.  I finally got around to connecting my Base 3 to the layout.  I have been running it in Conventional for the last several years after my old cab1 remote failed.   Now I'm trying to connect my Base 3 to the ZW-C but am having no luck.  The ZW is starting in command mode when the Base 3 is on so it is seeing the signal but that's it.  When I press the program button it does not attempt to problem, no lights flashing.  The green light stays steady and i have no output.  Could this be a failure within the ZW or does it see the Base 3 but not recognize it?  I'm not sure where to go from here, I cannot find anyone who has connected the two or a guide to do so anywhere.   Any guidance would be appreciated.

Thanks in advance,

Nick

Base3 should work with it although you most likely need to use a Cab2 or Cab1L to program and operate it.  The App seems to be having issues with Powermasters, ZW-Ls, and I suspect the ZW-C.  If it won't program with a remote, assuming you are program it correctly, you may have an issue with the ZW-C.

Last edited by MartyE

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×