Skip to main content

My hand control went "dead." Batteries were the originals, branded "GP." Rechargeble NiMH rated at 1.2v. Legacy is about 9 months old.

I tried non-rechargeble Rayovac  alkaline AAs, rated at 1.5v (Not in the charging base, of course!).

Then some rechargebles I have on hand. Also Rayovac. NiMH rated at 1.2v.

Both kinds bring the controller to life, but it isn't working "properly" with either! For example, it won't completely turn off. Holding the power button down blanks the screen but the backlight will not turn off. It will not come back on either, without removing the batteries and re-inserting them??

I've put the original "GP" batts back in. Same result now.

 

Replacing batts should not be this hard??

 

 

Last edited by Terry Danks
Original Post

Replies sorted oldest to newest

Wanted to update this forum with my recent experience specific to batteries.  My original legacy batteries went 'dead' and would not charge while in the remote and connected to the base.  I purchased replacement rechargable NIMH's and they are working very well.  Then this happened - I decided to see if my original legacy remote batteries would recharge in the recharge plug base in that came with the new batteries.  At first they did not - but after 2 days of putting them in and out of the recharge base -  guess what happened - they came back fully charged.  They now are fully charged and working as good as new!  go figure!

I too do not use the base to charge my batteries. I thought I read, or heard, some time back that one should not use the base to charge batteries. I use Costco or Duracell batteries and have never had any issues.

Also, earlier this year, my Cab2 controller had a bad key pad. I called Lionel service and was given a service ticket which included free shipping to Lionel. They repaired and even upgraded the software to both the remote and base at no cost to me.  It took about 10 days to get it back.

Lionel did an outstanding job and I greatly appreciated their continued support. Nice to know that there are somethings that Lionel really cares about.

RAY

@Bill Park posted:

Where do we buy replacement batteries for a Legacy controller?

They are normal AA NiMh rechargeable batteries. There are dozens of good well liked brands.

Edit:  I like watching Project Farm Videos and reviews of products. I may not always agree with testing methods or nitpicking, but he is independent, not sponsored, and just genuinely tests these things that people suggest. This one just happens to be AA Rechargeable common battery brands of various sources. https://www.youtube.com/watch?v=-jXQNY6rve8

I personally had been using Amazon - yes, they have their own "brand" and EBL. In my own mix of rechargeables, I also have some Duracell brand rechargeables from the local Bj's club. They all have been cycled through the remote (CAB2) and other uses on my layout in a continuous cycle now for at least 2-3 years.

I don't use my 990 set for charging, but I do have a 993 recharging base- it's just I'm bad about not parking the remote on it, so again, the batteries are often circulated in my recharging "pool" of batteries and so I can say that I have used several brands without issues.

Last edited by Vernon Barry

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×