I'm not sure whether the manual is in error or I don't understand it. I've wired up an ASC2 and it works exactly as described in the manual. I finished wiring up a BPC2 and it was driving me nuts. I followed the "Configuring the BPC2 for Track Addresses" as described on pg. 15 above the Note. I wired three blocks to be controlled. The BCP2's ID is TR4. So, when I push TR 4, AUX1 power is provided to Block 4...; next, TR 5, AUX1 and power is provided to Block 5 and the same for Block 6. If my very next command is TR 6, AUX2 Block 6 power is cut, but when I push TR5, AUX2, nothing, and again for Block 4. However, if I first push AUX1, then AUX2, power is cut. That's not how I read the manual on pg. 16 to control the blocks. It says: " press the TR button then press [in my case, 4] and then press AUX1 and AUX2 t turn the power block on and off." Is pressing AUX1 then AUX2 the correct way to turn the power block off as I have to do it, or have I done something wrong in programming, or is my BPC2 defective.
thanks,
Ed
