Its not easy to do because the two parts of the cab 1 cannot be separated far enough to have good access to the contacts.I have done one using a pencil eraser to clean the contacts and it worked better afterward.Good Luck
Remove the six screws on the back of the cab one, make sure you have a good proper fitting screwdriver as these screws are soft and the heads strip easily. Take note of which screws go where two are a bit longer. Then open the remote, I belive there are 3 more small screws holing the contol board against the keypad,remove these and gently pull the board away from the keypad.
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
Access to this requires an OGR Forum Supporting Membership
OGR Forum Supporting Membership
Help support this forum with an OGR Forum Supporting Membership. You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM! A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!
OR
Access the ALL the OGR VIDEO FORUMS ANDover 300 back issues of OGR with a DIGITAL SUBSCRIPTION!