Cab 2 repaired and batteries question

they are aa NiCad batteries!

what I would do is just put some regular aa batteries and just see if it works. also make sure the charging switch is on on the bottom of the base. I bought mine new and actually had to charge the original batteries with a separate charger because they were not originally charging to full charge only had 3 lines instead of 4 if I remember correctly. after that they charged normal! I have been told by asc techs the original batteries are not the best ! p.s. I use the separate charger that will charge 4 aa or aaa batteries and they work great!

if it works on regular batteries I'd say the cab 2 is ok make sure the bottom charging switch is turned on!

They are not NiCad. Look for eneloop AA NiMH 2400 mah. I have used Duracell AA NiMH 2400 mah as well. The eneloop ones hold their charge a little better when just sitting. You can also look at the original ones for type and size.

Don't put the remote back in the charger with regular batteries and the charging switch turned on. That switch should only be on when using the rechargeable batteries in the remote.  If you continue using the regular batteries, TURN OFF the charging switch.

I know what Alan was saying above, but it sounded as though it could be somewhat misinterpreted. Just trying to clarify a bit here. 

I use the same Duracell 2400mah batteries as cjack posted above. Been working perfectly now for 4 years. Way better than the original batteries. I recommend you not use lower capacity rated rechargeable batteries. 

If you use non rechargeable batteries any style is fine, turn off the charger as stated above.