Skip to main content

Reading some older posts on missing watchdog>starting in conventional and runaway issues in DCS mode. Using a Z4000 >WBBBBB resets to conventional allowing F/N/R. Further discussions suggested WBBB to lock it in neutral  to eliminate runaway in conventional or DCS mode. My question is can this be done using a Z Controller and a Z500 combo? Should this be done to all PS2/3 engines run in DCS mode for precaution?

Last edited by willygee
Original Post

Replies sorted oldest to newest

Willy,

My question is can this be done using a Z Controller and a Z500 combo?

Absolutely, yes it can. You should be able to do this with most, if not all, transformers that have both Bell and Whistle/Horn buttons.

Should this be done to all PS2/3 engines run in DCS mode for precaution?

No, not unless there's a reason to do so.

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×