Skip to main content

Here's the article: Trains News Wire EXCLUSIVE: Canadian National ore train
derailment was a runaway
Published: December 6, 2013
Two Harbors Tim Schandel
Ore cars from a derailed Canadian National
taconite train in Two Harbors on Thursday.

Photo by Max Medlin
TWO HARBORS, Minn. – The Canadian National ore
train that derailed in Two Harbors Thursday had air problems and was out of
control as it descended a 2.9 percent grade into Two Harbors, according to
sources familiar with the incident.


The 107-car train, U78982, had been loaded
earlier the same day at U.S. Steel’s Minntac Taconite Plant at Mountain Iron,
Minn. It was led by three units: DM&IR No. 407, an SD40-3 Tunnel Motor,
Bessemer & Lake Erie SD40-3 No. 909, and CN No. 6021, a rebuilt SD40-2. The
train crew first reported air problems as it approached Waldo, a junction four
miles north of Two Harbors. The crew reported to the dispatcher that they had
put their train in emergency for four miles and were still doing 40 mph. They
asked the dispatcher to line them directly into Two Harbors’ commercial
yard.


The crew was able to
bring the train to a stop just after Waldo and the beginning of the steep grade.
They told the dispatcher they would charge up their air and wait there, but one
grade crossing would be blocked. Since the crew was short of time, a pair of
units with a yard crew was sent out from Two Harbors to pull the train in. It
took about 45 minutes to couple the units and start moving again at about 12:55
p.m.


Now with DM&IR SD40-3 No. 405 leading, the train
made it about halfway down the grade when the crew called Two Harbors yard and
shouted their train was a runaway. It derailed and piled up as it entered the
yard.


There were four
crewmembers on board – the road crew and the yard crew from Two Harbors. Two of
them jumped as the train rolled into the yard and were injured, although three
feet of fresh snow may have cushioned their impact. Two others rode out the
runaway in the trailing units and did not have any injuries. CN spokesman
Patrick Waldron said an ambulance brought two people to an area hospital with
non-life threatening injuries.


The day before the accident the Two Harbors
area had received nearly three of snow, and the temperature at the time of the
incident was 9 degrees, so the weather may have been a factor in the
accident.


Railroad
spokesman Patrick Waldron declined to comment on the specifics of the radio
transmissions. He says, “All aspects of this incident remain under
investigation. We will not speculate on the circumstances nor what may have
contributed to or caused the derailment while that investigation is
continuing.”


According to
railroad spokesman Patrick Waldron, a total of 93 cars were involved in the
incident, 76 cars on the derailed train and 17 more loaded cars in the
yard.

Original Post

Replies sorted oldest to newest

If that article is accurate to what happened...

 

That train should NEVER have been moved again without AT LEAST an air-brake test.  I realize they were blocking a crossing and had a short-time crew, but after they reported difficulty getting stopped with the train in emergency, the brakes needed to be tested before moving the train again.

 

Again, IF the article is accurate.

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×