Skip to main content

Replies sorted oldest to newest

I also have the TMCC Tie-Jector. I'm very careful to stack the ties one-at-a-time and completely flatso that they aren't in any way skewed.

Still, occasionally the mechanism with try a few times before ejecting a tie. Then, it runs smoothly to eject the remaining ties.

Also, be careful to not stack too many ties. Just use enough to fill up the holding area.

Last edited by Barry Broskowitz

Thanks. I was careful loading as Barry suggests and it performed more reliably. Also I did watch the Lionel product video and Mike R. Just loaded them in and it worked fine. I suspect the alignment of the ejection scoop probably is key. Mine sits at a very slight angle. I'm going to open it up and see if there is a simple/easy way to straighten it out.  My grandson loves it! 

After spending some time with it I discovered the problem. First, one of the ties would hang up often. It's now on the work caboose. 2nd, if I stop the mechanism when it's in the full up position then load in as many as 11 ties, it works flawlessly 9 out of 10 times. I'm satisfied. It's a very cool, entertaining operating car. 

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×