engine was running fine and all of a sudden it came to a stop and tripped the circuit breaker. ohm meter shows a dead short from center rail rollers to drivers. what would cause this
Burned up AC input wire shorting, or the board has a direct short. Pull 7 pin connector from board. If short goes away the board is most likely bad, If short stays, the wiring is bad. G
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
Access to this requires an OGR Forum Supporting Membership
OGR Forum Supporting Membership
Help support this forum with an OGR Forum Supporting Membership. You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM! A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!
OR
Access the ALL the OGR VIDEO FORUMS ANDover 300 back issues of OGR with a DIGITAL SUBSCRIPTION!