Skip to main content

Replies sorted oldest to newest

for those without a 3D laser printer and wanting to know where your remote is at all times this is great. Also, if you still dont use your iPad or Android to control your trains.

If you have a 3D laser printer, this is an easy print that depending on orientation within the printer the longer holder shown above could take anywhere from 6 (flat print) to 23 (vertical print) hours to print in gray resin.

So this cost is dependent on the value of your print time.

NOTE: If someone wants to try and make money from their 3D designs and prints, I have decided that I will no longer provide models on this site that are free and could be competitive.

Instead, I wish them luck.

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×