What is the correct way to wire all three for operation. I currently have the DCS and Tmcc command module connect with the MTH interface cable. My legacy is not connected to the track. Can I just run the track wire from the Legacy to the TIU output with the TMCC on the same connector?
Replies sorted oldest to newest
BillSRR,
Yes you can do it that way, however I also most times run a Legacy drop directly to the opposite outside rail from the DCS. This sets up a double Legacy signal. Learned this from MartyF a while back, and it works very well. However I was getting some intermittent interference with my FT Command Control Switches running in this manner, for some unknown reason. On my newest layout I am using the opposite rail only and it fully eliminated the FTCC interference, however my signal is not quite as strong, but I have no running problems on the FT. With the old 711/072 switches and conventional Tubular with the manual switch controllers, I still double side the Legacy signal and use LED's in the controllers and switches.
PCRR/Dave
On an earlier layout I had the TMCC base plugged into the Legacy base and I ran DCS as well. I do not have it set up right now; however, if you want to use the CAB 1 controllers, I think you will need the TMCC base; however, I am running my TMCC operating accessories and my ERR modified SMR engine without the CAB1 or the TMCC base. I may need the TMCC base if I decide to utilize my TMCC gantry crane (direct cable to the base); however, I do not think I will have the space for it.
Access to this requires an OGR Forum Supporting Membership
