Do u have a magic wand? Adding a MTH DCS Engine...

John,

Try recovering the 44 tonner. Using a TIU with an ID# of 1:

• The all other engines off the tracks.
• Place the engine on the track.
• Put power to the engine.
• Press: Menu/System/Engine Setup/Recover Engine

If it's recovered, re-add it to a DCS Remote.

I hate to tell you this, JRC, but clearing/resetting all remotes is not a good idea, and can accomplish nothing at this point.  If you had saved one of them to your computer, you could do a restore.

I would have suggested saving one remote to the computer.  Then resetting it, placing only the 44T on the track, and with the completely clean remote doing an add engine.

Barry Broskowitz posted:

John,

Try recovering the 44 tonner. Using a TIU with an ID# of 1:

• The all other engines off the tracks.
• Place the engine on the track.
• Put power to the engine.
• Press: Menu/System/Engine Setup/Recover Engine

If it's recovered, re-add it to a DCS Remote.

Barry:

You are the man!  No wonder you wrote the book.  I was beating my head against the wall and did everything I knew and everything that had been suggested to me.  When I read your post I immediately walked downstairs and did as you instructed and within a split second I saw "Engine Recovered."  I then did the "add" thing and wham!  It is there.

I really appreciate all your great advice.  I'd like to send you a complimentary copy of my book.  If you PRIVATELY message me I'll send you one.  :-)  Thanks again!

John 

John,

I thought that might correct the problem...