The link on 3rd Rail's website for the CC Lite manual doesn't work.
I'm revisiting a Budd RDC that I installed a CC Lite and Sound Board in a few years back. It doesn't seem like the cruise works.
--Is it the same procedure as the current Cruise Commander?
--Can it be done with the Legacy remote or do I have to use Cab-1 (not currently hooked up) ?
--Do I do it with switch in Run or Program mode
Thanks in advance.
Replies sorted oldest to newest
Here's the CC-Lite installation manual.
Thanks. Figured out the programming. Switch in program mode, must use Cab-1.
Needs to be in small motor setting. Took off like a Corvette when I tried the large motor setting!
Not a big deal but can't get the feature code to work. I was going to tie it to the interior lights but nothing. Tried to reset feature code to 6, nothing. Always on, never shuts off.
The cab lights don't work that way. You can manually switch them on and off using the AUX1/9 and AUX1/8 keys on the CAB1.
Turns out it was a wiring issue. One of the lights was still connected to an always on source. Snipped that wire and now all 3 cabin lights turn on and off with Aux1/9 and Aux1/8.
What would be the best BA9 bulbs to use coming off that feature output for lighting the cabin? I currently have something that says 12V0.1A in there.
One or two of those should be plenty, the cab shouldn't be brighter than sunlight! 
I normally use one small 3mm 60ma bulb for the cab light.
It's 3 lights lighting the interior of an RDC. What I should really do is put an LED strip above!
Yep, I'd do it with an LED strip. If you add a diode in series with the LED strip, you can power it directly from the smoke/feature output pin.
Access to this requires an OGR Forum Supporting Membership
