Hi ,
have a 30-1224-1 MTH berkshire proto2.0 - 5volt board. The tender light on back is burned out.
I tested a evans universal led which has the bridge rectifier for ac or dc led rated 7-19 volts and it went on.
My small dcs layout powered by postwar zw on at 16-17 volts.
My question is can i use this or will i have to order the original from MTH.
Thanks
Replies sorted oldest to newest
If it works, use it. You're not hurting the board if that's what you're asking. I put LED's in PS/2 all the time, I use a standard 3V white LED and a 200 ohm 1/4W resistor.
John thanks .That was my concern the board as i cut right below old led and spliced in the evans led .
Good to hear that its compatible and nice easy fix for something i had in parts box.
Access to this requires an OGR Forum Supporting Membership
