Skip to main content

Is there a wiring diagram for the Fast track remote switches?  Mine are acting up and I'm not sure I wired them correctly.  I did have to undo both switch wires to feed up through the table, and am sure I have all 4 wires going to where they were originally (I marked it with a sharpy before undoing them.  For power, I'm relying on track power...do I need to add a seperate lead for power to help things out?  I'm using a CW 80 transformer and can easily install new leads off my main lines if thats whats needed?  I'd like to see actual pictures of what it should look like once wired (I'm a visual type learner).  Thanks everyone. 

Original Post

Replies sorted oldest to newest

Hi, I think that all of the diagrams that you need are in the FasTrack remote switch manuals. Here are excerpts from the manual in case you don't have one handy.

 

 This is the diagram for the remote switch connections.

 

Screen Shot 2013-02-19 at 20.48.05

 

 

If you are running conventionally, you may wish to run wires from the accessory terminals on your transformer to the switches. This way you can still operate them when the track power is very low, or off. Here is the diagram and instructions for this.

 

Screen Shot 2013-02-19 at 20.48.33

 

I hope the above is of help.

Attachments

Images (2)
  • Screen Shot 2013-02-19 at 20.48.05
  • Screen Shot 2013-02-19 at 20.48.33
Post
×
×
×
×
Link copied to your clipboard.
×
×