Fat Fingers & Run Away Trains

You are probably way ahead of me, but did you try setting each engine after the lash up is created? I think that is the way it works with the remote, but I have not tried it with the app. That is if the setting is even still available that way? I have not done a lash up in quite some time and have never tried setting the speed afterward...

Maybe Barry or others with more knowledge than me will be along.

Good thought about the sequence.  I will delete the lash-up, then set the speed on the two locos that I want to lash-up, lash them up and see if the max speed is reduced.  If this works or not, I will reply, but probably with a more descriptive title.  You are the only one that replied to my initial post probably because of my attempt at humor in the title.  Thanks, Tom

Maybe I worded that wrong above?  I meant create the lash up first and then set each engine individually.  

Kind of surprised no one else has been along to reply? Maybe the re-title would help too?

You were very clear in your earlier response, which is what I initially did.  Then, I thought well maybe I should do it in reverse and that didn't work either.  I don't believe the app allows the operator to set a max speed for a  lash up, and hopefully this will be addressed in a future release.  But, we will see what replies I get after I re-post the issue tomorrow with a different, more concise title.  Thanks for replying.

Tom

You are welcome, just wanted to make sure. Hate to see things go by with no reply, sometimes a bump will help, but not here I guess. Hopefully Barry and the others will comment on the next thread!

Still nothing? Not even a confirmation? .