Skip to main content

I’ve been at this a long time, but leds and wiring are not a strong suit.  I purchased a plasticville signal bridge. I had someone put led lights in it and I’m busy getting ready to wire it up.

What I don’t understand is it appears that he used copper non insulated wires for common and anode.  They are all wrapped up together but don’t short when power is applied. I don’t understand how that works.  4A866683-6CB4-4649-AF79-7CAE1E4AA980

Attachments

Images (1)
  • 4A866683-6CB4-4649-AF79-7CAE1E4AA980
Original Post

Replies sorted oldest to newest

@davidbross posted:

I’ve been at this a long time, but leds and wiring are not a strong suit.  I purchased a plasticville signal bridge. I had someone put led lights in it and I’m busy getting ready to wire it up.

What I don’t understand is it appears that he used copper non insulated wires for common and anode.  They are all wrapped up together but don’t short when power is applied. I don’t understand how that works.  

Why not contact the person who did the wiring and ask him???

The wires should be fine if you don't kink them against each other a lot. They are insulated.

Magnet wire

Copper or Aluminium Wire
Magnet wire
Magnet wire or enameled wire is a copper or aluminium wire coated with a very thin layer of insulation. It is used in the construction of transformers, inductors, motors, generators, speakers, hard disk head actuators, electromagnets, electric guitar pickups and other applications that require tight coils of insulated wire.



He labeled them for you. Did you specify the operating voltage you wanted? Looks like he added resistors for that voltage.

Attachments

Images (1)
  • blobid0
Last edited by Engineer-Joe

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×