Well I have crossed over and hooked up my first DCS TIU and remote. I have the latest TIU version L and the latest software.
I have installed the TIU per the instructions using the transformer to fixed input 1- fixed output 1 to track. was able to add the read and confirm the TIU recognizes remote. Placed the engine on the track. Add engine, found engine... and away it went. Things are good.
added in two more engines... and did a test on track signal... all 9s and 10s. Legacy is also hooked up on the track and all is good with them.
I have a 30 X 30 layout and the TIU is under the table. As I walk about 15 feet away from the TIU I cannot blow the horn/bell/brake/ or change the throttle. Take a few steps back towards the TIU and I am good to go... go a few steps away and happens again. Run a different engines same thing...
Is there a way to extend the remote to TIU range? Does the remote need to be in the relative "line of sight" of the TIU?
swapped out the remote with a brand new one... same thing, only 15 ft to 20 ft of range.