Hello again, I replaced the smoke resistor and found the chug switch covered in smoke fluid, my bad. So after I removed and cleaned (alcohol swabs) I ohmed it at the 2 outer pins and found out it was always open (no continuity) while I worked the switch. But found switched continuity on 1inner and one outer pins. I wired to them and buttoned it up. Now I have erratic chuffs,full railsounds, headlite stays on in reverse when in conventional op. I reset to code 4 and now I have erratic commands and the throttle needs 20 turns to move in any direction, no crewtalk or whistle. Reset again code 47 and saw a different reaction but no help. Went back to code 4 again same thing. Should I just get a new micro-switch and start over? Thank you all
