It appears that at least the sets I got have very bad tolerances, especially the gradulated sets. The posts that go into the bases are so tight that when you go to take them out, it literally rips the base out of the table even though they are held in with two screws. Has anyone else had this problem? I even bought forester bits & drilled the holes slightly bigger & it hasn't helped much at all. Probably need a bit 1/64" bigger, but it is not made. Sanding them with a round Dremel tool doesn't seem feasible. Would appreciate any suggestions. The forester bit a 1/64" bigger would pobably do it ,but can't find one. I used a 7/16" bit.
Original Post
